Experienced RF Test and Evaluation Electronics Engineer with Circuit Design and PCB skills desires additional career challenges.
Work Experience
Instructor ITT June 2014 – Present
Develop Lectures and Lesson plans for students for a given subject.
Provide Guidance to students for their Development.
Provide feedback to students to allow them to focus their efforts.
Guide students through Labs to demonstrate fundamental principles of operation for devices.
Design Engineer Intelligent Fundamentals, LLC Jan 2012 - Present
Design of high-speed serial data acquisition hardware. Protocols include ARINC 429, RS-422, RS-485, and RS-232.
Provide C++ Digital Signal Processing customer code support.
Perform Printed Circuit Board (PCB) designs for Analog and Digital systems.
Resolve and Provide EMI/EMC compliance guidance (DO-160x).
Production Test Engineer Contractor Jan 2005 – June 2008
Evaluation and Qualification of Production Products for Customers.
Analysis and Improvement of the Design of Product Test Platforms.
Electronics Engineer UPS Aviation Technologies August 1997 – April 2003
Responsible for performing complete Radio Frequency (RF) Emissions, Induced, and Susceptibility test efforts for products per FAA DO- 160 Environmental Conditions and Test Procedures for Airborne Equipment.
Electromagnetic Environmental Effects(E3) of RF from Emitted from and onto the Device Under Test(DUT), and E3 Induced onto the DUT whether it is Conducted or Radiated.
Responsible for test equipment support of RF Test equipment from the Anechoic chambers, Lightning Simulator, RF Cable Induced, ESD equipment, I/O interface devices, RF power meters, an operational C++ coding for all of the test equipment.
Guided Project teams and evaluated the DUT test results from design inception and resultant test reports submitted to FAA guidelines for approval of Device Under Test (DUT).
Directed and performed MTBF efforts and estimates for products.
Team Member of a prototype Traffic Collision Avoidance System(TCAS), provided hardware circuit designs for Mode C transponder.
Designed a RF-hardened timer circuit for GPS Time-mark comparisons between two GPS Receivers for manufacturing and test divisions.
Designed a novel RS-422 Fiber-Optic Interface for DUT in response to data corruption from RF Induced into DUT to allow tests to completed in a timely manner.
Project Team Leader for a Auxiliary Control Unit(ACU) from design to manufacturing support.
Electronics Engineer DP-855, DP 1-22
Naval Warfare Center June 1995 – August 1997
Demonstrated a SSB FM chirp waveform-generator using digital design technique’s...
Login or Register to view the full resume.
